乡镇医院污水处理设备
.公司(http://www.chemdrug.com/company/)概况
乐斌-方佳环境我厂是集技术研发、项目设计、设备制造、工程安装、调试运营、技术咨询服务为一体的专业型水处理公司。我公司根据国内水处理市场的需求，结合国内外水处理产品**的设计理念，将国外先进的水处理技术和精湛的生产工艺溶入到中侨水务系统的产品体系中，继而研发创新，产品自投入市场以来，深受广大消费者信赖
MBR工艺处理医药污水的特点：
采用膜生物反应器作为主处理单元，它具有抗冲击能力强，出水水质优质稳定，其处理构筑物全部置于地下，占地面积小，布局合理。PLC柜置于地上控制室内，使管理较为简单。MBR工艺由于高效的固液分离作用，出水悬浮物浓度低，细菌和病毒失去了附着或包裹的屏障，易于被灭活，能有效去除SS和细菌。膜组件的高效截留作用使反应器内保持了较高的生物量，提高了生物处理效率，由于MBR的截留作用使微生物富集，可使世代周期较长的硝化细菌得以保留和繁殖，从而到达了很好的脱氮效果。反应器内微孔曝气，不仅提高了充氧效率，而且优化了反应器的水力条件。微孔曝气给生物接触氧化提供了足够的溶解氧，曝气系统有助于膜两侧的翻水，强化了气体对膜的剪切作用，有利于气液两相流间的传质，使处理系统的正常稳定运行。医院废水处理产生的剩余污泥中含有大量的细菌和病原微生物，处理不当会造成二次污染。所以维持在高污泥浓度条件下运行，可有效地解决排泥问题。MBR剩余污泥产量低，并且将剩余污泥回流到调节池中，从而达到系统污泥零排放，大大节省了污泥处理的经费问题，有利于污泥资源化管理。
地埋式医院污水一体化处理设备的优点：
1.环保工程生产的一体化污水处理设备经本厂碳钢防腐处理或不锈钢构件，现场拼接组合而成。重量轻巧，易于运输，方便安装，耐腐蚀，使用寿命长；
2.结构合理紧凑，埋于地下有利保温，在寒冷的冬季(-30℃)仍可正常运行，适应中国南北广阔的气候环境；亦可安置在水塘中，借用地形融入周围环境，减少占地面积。
3.无污染，无噪声，无异味，减少二次污染；
4.医院污水处理设备不受污水量的限制，机动灵活，可单个使用，也可多个联合使用。
5.自动化程度高，能耗低，管理费用小；
6.净化效率高，BOD去除率在85%～90%，出水各项指标达到国家《城镇污水处理厂污染物排放标准》(GB18918—2002)的二级或一级(B)标准，可达标排放。目前客户多要求进一步配套，作臭氧强氧化深度处理，达到《城市污水再生利用景观环境用水水质标准》(GB/T18921—2002)标准，再生利用。
7.Zui大的特点是可以将污水处理工程布置成景观。因为埋于地下且出水效果好，地表绿化率可达90%以上，若使用耐寒喜水的特殊标志性树种或草坪，形成溪流、喷泉、水塘、鱼池融为一体的水处理景观，化污浊为清泉，既治理了污水又美化了环境，满足人们依山傍水而居的愿望。
废水处理-建筑物的设计要求
1、处理构、建筑物及主要设备应分二组，每组按50%的负荷计算;处理构、建筑物时应采取防腐蚀、防渗漏措施;确保处理效果，耐用，操作方便，有利于操作人员的劳动保护;
2、污水处理构筑物应设排空设施，的水应回流处理;在寒冷地区，处理构筑物应有防冻措施;当采暖时，处理构筑物室内温度可按5℃设计;
3、加药间、检验室和值班室等的室内温度可按15℃设计;高架处理构筑物应设置适用的栏杆、防滑梯和避雷针等措施。
4、污水处理站排水一般宜采用重力流排放，必要时可设排水泵站;处理站的附属设施及相关要求
污水处理按照其作用可分为物理法、生物法和化学法三种。
乡镇医院污水处理设备
问题突出表现在：建设滞后，农村污水处理设施覆盖率偏低，农村58%的生活污水未得到有效处理。设施运行效率不高，农村生活污水处理设施建设普遍存在厂网建设不完善的问题。农村污水直排问题不容忽视，污水收集管线没有接管入户，都市人群赴郊区旅游导致农村集中排污现象加剧。缺乏运维经费和专业维护。北京市尚未出台处理设施运行经费拨付办法和标准，基层设施管理不到位、运行效率偏低。
工艺特点：加强处理效果的一级强化处理可以提高处理效果，可将携带病毒、病菌的颗粒物去除，提高后续深化消毒的效果并降低消毒剂的用量。其中对现有一级处理工艺进行改造可充分利用现有设施，减少投资费用,Afterhydrolysis and acidification, the wastewater enters oxygen-poortank, contact oxidation tank and secondary sedimentation tank inorder to circulate, so that the wastewater is in the environment ofanoxic and oxygen-enriched cycle transformation, and the followingtransformation can be achieved.- Denitrification; convertingorganic nitrogen into ammonia nitrogen, transforming ammonianitrogen into nitrite nitrogen and nitrate nitrogen through aerobicmicrobial nitrification bacteria, and then transforming nitritenitrogen and nitrate nitrogen into nitrogen through anaerobicmicrobial denitrification bacteria, escaping from sewage-phosphorus removal; high phosphorus content sludge is formed byphosphorus accumulating bacteria releasing phosphorus in anoxicenvironment and absorbing excessive phosphorus in oxygen-richenvironment.- Degrading organic matter thoroughly; On the basis ofhydrolysis acidification, utilizing the characteristics of rapidpropagation of aerobic microorganisms in oxygen-rich environmentand rapid propagation of anaerobic microorganisms in anoxicenvironment, degrading organic matter in turn and transforming itinto sludge(3) Disinfection of sewage to meet dischargestandards(4) Regular removal of sludgeThe characteristics of sewagetreatment methods in small and medium-sized hospitals are asfollows: the volume of the oxygen-poor pool is much smaller thanthat of the contact oxidation pool. When the sewage circulates, theresidence time in the oxygen-poor pool is very short, while theresidence time in the contact oxidation pool is very long, so thatthe sludge produced by biochemical treatment is mainly deposited inthe contact oxidation pool.The characteristics of sewage treatmentmethods in small and medium-sized hospitals are as follows: theoxygen-poor pool is composed of adjusting aeration pool and anoxicpool in series. The two pools are connected structure. By changingthe aeration degree of the adjusting aeration pool, the sewage isfully mixed and the water is uniform.4. The sewagetreatment method for small and medium-sized hospitals as describedin claim 3 is characterized in that the sewage treatment stationalso includes a sludge concentration pond which is connected with acontact oxidation pond, and the sludge concentration pond ise with a refluxpipe.与调节曝气池连通，回流管路上配有回水泵，开启回水泵，将污泥浓缩池的上层污水泵回调节曝气池，使下层的污泥浓缩，也使接触氧化池中的污泥持续进入污泥浓缩池Thecharacteristics of sewage treatment methods in small andmedium-sized hospitals are as follows: chlorine dioxide is injectedinto the drainage pipe of secondary sedimentation tank; chlorinedioxide flow rate is accurately measured by metering pump to reduceresidual chlorine residue; at the same time, water body issufficiently mixed from the contact oxidation tank and aerated byblower to reduce dosage.6. The small and medium-sized hospitalsewage treatment method described in Fig. 4 is characterized bythat the sewage return flow R = 1:1, i.e. the sewage circulationflow: the treated discharge flow = 1:1.At present, the total numberof medical units above county level (including industrial andmining enterprises hospitals, military hospitals, private hospitalsand Sino-foreign joint venture hospitals, etc.) in our country(except Hong Kong Special Administrative Region, Macao SpecialAdministrative Region and Taiwan region) is about 21,000, of which1041 are tertiary first-class hospitals, accounting for about 5% ofthe total number of hospitals, 90% of which are small andmedium-sized hospitals below secondary level, relatively speaking,large hospitals. All of them have more standardized wastewatertreatment systems, and are e with professional maintenanceand management. However, due to the reasons of fund, operation costand personnel , a large number of small and medium-sizedmedical institutions are weak in the construction of medicalwastewater treatment facilities, and their operation is notcompletely normal, which is a difficult and important point incurrent pollution control.The sewage discharged by hospitalsconsists of two parts, one is domestic wastewater, the pollutantsare mainly organic matter, the other is medical wastewater, thepollutants are mainly nitrogen, phosphorus and so on. At present,most of the small and medium-sized medical institutions in ourcountry generally adopt the first-level intensified treatment. Thetypical process is as follows.The characteristic of the first-levelintensification process is that it can effectively controlpathogens through disinfection process, but the removal effect ofCOD and BOD is not good and can not meet the re ofenvironmental protection.In recent years, with the progress ofsocial economy and the improvement of people"s awareness ofenvironmental protection, more and more small and medium-sizedmedical institutions have built a number of secondary biochemicaltreatment facilities. The processes adopted include A/O, SBR,oxidation ditch and contact oxidation.As can be seen from Table 1,three biological treatment methods, A/O, SBR and oxidation ditch,all have good treatment effect.However, for small and medium-sizedmedical institutions, due to the lack of funds and managers, theremay be insufficient funds in the actual implementation process, orthere may be inadequate management and excessivedischarge.Relatively speaking, contact oxidation method is moresuitable for sewage treatment in small and medium-sized medicalinstitutions, but contact oxidation method lacks oxygen-deficientstage, so the ability of denitrification is weak. Nitrogen ineffluent is basically converted to nitrate, ammonia nitrogen mayreach the standard, and the essence of total nitrogen has not beenremoved.The purpose is to overcome the shortcomings of theabove-mentioned treatment methods and provide a more suitabletreatment method for sewage treatment in small and medium-sizedhospitals. The treatment process of this method is simple, occupiesless land, has low construction investment and operation cost. Itcan not only meet the sewage treatment standards, but also is easyto operate and manage, and has low re for the ofoperators.,大家纷纷表示，在今后的日常生活和环保行动中，将从我做起，从小事做起，节约用水，珍惜水资源，同时号召身边的人一起节约能源，提升环保意识，努力建设和美邢台！（通讯员韩亚丽 王康）